Six connected capabilities that carry your ferrous scrap from first enquiry to a weighed, documented consignment at your furnace door.
Cold-rolled coil baled scrap, hydraulically baled to a consistent density with minimal coating and rust. A high-yield charge material for SG (ductile) iron and grey iron melts.
Sheet cutting scrap trimmed from cold- and hot-rolled sheet processing, sorted to remove contamination and prepared as uniform busheling for direct furnace charging.
Punchings and offcuts collected from stamping and press lines, screened to remove fines and flash and de-oiled before dispatch so your melt chemistry stays predictable.
Each lot is inspected, segregated by grade and cleared for contamination before it leaves the yard. Where your process requires it, we share chemistry data from our partner laboratory.
Road and rail dispatch across India with GPS-tracked loads and weighbridge slips, scheduled around the delivery windows that suit your melting plan.
Straightforward commercial terms with transparent pricing, GST-compliant invoicing and repeat supply contracts that keep your feedstock availability predictable.
| Material | Grade codes | Typical source | Grade consistency |
|---|---|---|---|
| CRC Baled Scrap | CRC · Hydraulically baled | Cold-rolled coil scrap, baled for high-density, low-residual charging. | 99% |
| Sheet Cutting Scrap | Busheling · CR and HR sheet | Trimmed sheet cuttings, sorted and sized into clean furnace busheling. | 98% |
| Press Shop Punchings | Punchings · Stamping offcuts | Stamping-line punchings and offcuts, screened and de-oiled on request. | 97% |
| Light Melting Scrap | LMS · Light gauge | Thin-gauge light melting scrap, baled to suit cupola and induction charging. | 95% |
| Plate & Structural Cuttings | HMS · Plate and structural | Heavier plate and structural cuttings for charge-weight flexibility. | 96% |
| Re-rolling End Cuttings | End cuts · Coil ends | Coil ends and re-rolling end cuttings, trimmed and bundled. | 94% |
Tell us the grade, tonnage and delivery schedule you need. We confirm availability and quote the same day.
Material is collected from press shops, sheet processors and OEM stamping lines across our supplier network.
Every lot is inspected, segregated by grade and checked for contamination before it is accepted into the yard.
CRC and light-gauge scrap is baled to density, while busheling is sized and de-oiled where your process requires it.
Each consignment is weighed, documented with a slip and GST invoice, then dispatched to your foundry.
Share the grade, tonnage and destination you have in mind, and we'll confirm availability, pricing and a delivery window the same working day.